Currency
Removing
 x 
Recently added item(s)

2720 Spyder - Fulcrum

 

Stock replacement parts and options listed on these pages will fit the 2720 Spyder fulcrum tremolos only. Discontinued in 1992, not all parts listed below are available. Only the parts shown below are in stock. FYI: The Spyder had 3 different model versions which all had to do with the saddles. Saddles came in different styles: non locking (#5344), finger locking (#5338) and wrench locking (#5581 as shown). Wrench locking were the most common with an 85% share. It used a 3/32 Allen key to tighten the string lock bolts on the first versions and eventually an upgraded 1/8" Allen/slotted combo string lock bolt later on. The finger locking type saddle had jet thruster looking knobs that you turned to shut an opening similar to a missile silo hatch that pulls back and then shuts again to lock the strings just like the 2710 Killer saddle shown in the blue picture, middle. The non locking saddle simply had a string hole for it to pass through. The strings ball end caught the end of the smaller entry hole and was held. Also note that a Kahler 2720 tremolo always had "Spyder" stamped on the shoulder.

 

Results 1 - 18 of 22

This is a Kahler Large Stud or Post Insert.

$10.00

This universal set contains all the Allen keys that are used for all the Kahler models.

$7.00

This is the Kahler fulcrum arm that came stock on several models.

$29.00
Options:

This is the Kahler standard knife edge post and uses a 3/32" Allen key. It screws into wood insert #9476.

$8.00

This is a Kahler standard post insert.

$10.00

This is the Kahler heavy duty large post that has a Phillips head.

$9.00

This is the Kahler fulcrum spring claw that you always find in the spring cavity on the back of guitars that use a...

$4.00

These are the proper tension fulcrum springs for Kahler and Schaller tremolos.

$4.00

Turn your fulcrum into a dive only bridge. This Kahler fulcrum tremolo stop fits any guitar that has a back plate to...

$25.00

This is the small shaft fine tuner for the Kahler 2710 Killer (2700 Series) or the 2720 Spyder.

$7.00

This is the large shaft fine tuner knob for the 2760 Steeler. This might also be the fine tuner for the 2720 Spyder...

$7.00

This is an arm clutch for the Kahler 2710 Killer and the Kahler 2720 Spyder. It is the arm clutch and the plug in one.

$4.00

This Kahler right hand arm module only works on the 2710 Killer, 2720 Spyder and later versions of the 2760 Steeler. 

$40.00

This Kahler left hand arm module only works on the 2710 Killer, 2720 Spyder and later versions of the 2760 Steeler. 

$40.00

This is the intonation screw that tightens the Kahler 2720 Spyder saddle to the base plate after you intonate.

$1.00

This dual model screw serves as both the Kahler bass bridge and the Kahler 2720 Spyder saddle intonation adjustment...

$1.00

This is a string lock block replacement for the Kahler 2720 Spyder.

$15.00

This is the string locking bolt that you lock the strings with on the Kahler 2720 Spyder.

$9.00