This is the TOM mounting stud for all Kahler stud mounted tremolos.
This is a Kahler Large Stud or Post Insert.
This is a Kahler riser wheel for all stud mounting tremolos.
This is the Kahler riser wheel insert. It is pressed into into the body.
Kahler mounting plate adjustment screw is used to help adjust the intonation forward/back position of the entire stud...
This is the front mounting screw for the Kahler tremolo and fixed bridge systems.
This is the Kahler mounting screw for bass tremolos that also doubles as the rear mounting screw for the guitar...
Standard arms are the arms for all Kahler CAM system guitar tremolos.
The Kahler Heavy Metal arm (HM arm) is based after the Floyd Rose arm.
The standard bass arms are 9 inches long and have more leverage than the stock 6 inch Kahler arm which doubles as the...
If your tremolo says Kahler FLYER, this is the original stock arm it came with.
The XL bass arms are 12 inches long and have more leverage than the 9 inch long Kahler arm.
You can use both the Kahler standard or wide tremolo string hooks on any past or current CAM system including the...
This Kahler shorter CAM locking screw locks the CAM to the frame and turns the TOM mounted Kahler into a fixed bridge.
This Kahler longer CAM locking screw locks the CAM to the frame and turns the flat mounted Kahler into a fixed bridge.
The Cam Ball Bearing is pressed into the side of the CAM.
This is the bearing bolt for all Kahler CAM tremolo systems.
This is the Kahler arm tension adjustment screw for the arm clutch.
The Kahler FLYER intonation and CAM stop bolt is a dual purpose screw.
This is the 2 spring load lever that was used on a small lot of the single piece cam/cam cage assemblies found on the...
This is a two Kahler spring load lever. It holds a pair of either the 8412 or the 8413 springs in any match up to...
This is a Kahler 3 spring load lever. It holds a trio of either the 8412 or the 8413 springs in any match up to achieve...
It is the pivoting pin for the load lever that adjusts the springs.
You use the load lever screw to adjust the Kahler tremolos spring tension.
This is a locking clip for all Kahler CAM guitar and bass tremolo systems.
These standard tension return springs are the correct tension springs for all Kahler 6 string guitar systems. Will also...
These heavy tension return springs are the correct tension springs for all Kahler bass tremolo systems. These can also...
This is a tension return spring mounting screw.
This is the Kahler CAM cage that contains the 6 "top loading" string hooks that the ball end of the string...
This is the Kahler fixed bridge string hook for all fixed guitar bridges with fine tuners.